pro-intell PRO 85 Manuel D'utilisation page 22

4. "CLR" button
Reset display 2. Press this button to exit batch mode.
5. "START" button
• starts and stops counting
• zeros counting results on the main display 1
• continues counting and resets error messages on the display 2
• stores changes in settings
6. "SP" button
This button changes the counting speed. Each pressing of "SP" button changes the speed.
The main display will show the current speed: 900/1200/1500 banknotes/min. After pressing
the "START" button, the counter will save the set speed value and use it as the default in the
future.
7. "DD" button - width detection mode ON/OFF button (indicator lights up if ON)
8. "UV" button
Switch ON /OFF UV detection (indicator lights up if ON)
9. "MUL" button
This button chooses manual or automatic counting mode. Press "START" button to start
counting in the manual mode.
In automatic mode the counter starts automatically when you place a stack of banknotes in
the hopper, (indicator is off by default).
10. "ADD" button
ON/OFF summation mode. (Indicator lights up when ON)
11. "CUR" button
This button allows toggling the device for the different types of supported currencies. Each
pressing of "CUR" button changes the currency type in the order of "RUR", "USD", and
"EURO". Indicator (Fig. 2-13) is lit.
It is important to set the type of the currency to be counted to ensure accurate results. An
indicator will light up according to the currency selected. When no indicator is on, the device
is set to "other currency", see Table 6.1. The counter will authenticate banknotes according
to the default settings of the device and not according to currency-specific settings.
12. "MG" button
This is a magnetic detection ON/OFF button.
13. Currency type indicator
This indicator shows the selected type of currency. No indicator lit corresponds to "other
currency".
22