pro-intell PRO 85 Manuel D'utilisation page 24

6.1.2. Banknote width detection
Detecting the width of a banknote aids in authenticating that note. If the counter recognizes
the size of a banknote is smaller (for example, a sensitivity level of dd = 4 corresponds to 4
mm) than the previously counted banknotes, the counter will alert the operator to the
presence of a suspicious note. This can also be used to sort banknotes by detecting the size
differences between different face values of a given currency. If none of the currency
indicators is on, width detection is ON for any type of currency.
6.1.3. UV detection
The PRO 85U and PRO 85UM models incorporate UV detection. Press the "UV" button to
switch UV detection ON / OFF (indicated by the backlight indicator). When a banknote with
suspicious UV reflection properties is scanned, the counter stops counting and will display an
error message "Eu". The suspicious banknote will remain on top of the stack for the user to
remove and examine. After removing the suspicious banknote, the counter will continue
counting without including the suspicious banknote in the total. If none of the currency
indicators are on, UV detection is ON for any type of currency.
6.1.4. Magnetic detection
The PRO 85UM model includes magnetic detection along with UV detection.
Depending on the banknote position (smaller in size), it is possible that the counter will not
recognize a suspicious banknote and will continue counting.
When a suspicious banknote is recognized without the proper magnetic marks, the counter
stops and an error message "En" will be shown on the display. Suspicious banknote will be
placed on the top of the stack of banknotes. The banknote is not added to the total result.
Attention! When magnetic detection is on, it is necessary to align banknotes in the middle of
the auxiliary hopper plates (Fig. 1-4). In the event of improper alignment, an error "En" will be
shown on the display. When none of the currency indicators is lit, magnetic detection is OFF.
6.2. Counting procedure
Choose the currency type by pressing the "CUR" button before counting. Indicator (Fig. 2-13)
shows the chosen currency type.
Attention! In order to avoid errors during counting, resort banknotes and put aside banknotes
that have been subjected to excessive wear and tear, are folded, or have been subjected to
substances that may have altered the UV / magnetic properties of the ink.
Banknotes should be placed in a neat stack before being placed into the hopper!
• Banknotes are to be placed in the hopper
• The counter will start automatically after one second
• Display 1 will show the results
• Repeat again up to Table 6.2., when necessary
• Press "START" button to reset display when finished
• If an error occurs during counting, see Table 8
6.3. Batch mode
(This mode allows for counting a user specified number of banknotes from a larger stack).
• Enter a number corresponding to the amount of banknotes to be counted on Display 2
• Repeat from the beginning of Table 6.2., when necessary
• Remove banknotes from the stacker
24