Black & Decker CS2040 Mode D'emploi page 9

Labels on tool
The following pictograms are shown on the tool:
:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
O
Wear safety glasses or goggles when operating
this tool.
N
Wear ear protection when operating this tool.
R
Do not expose the tool to rain or high humidity.
Directive 2000/14/EC guaranteed sound power.
E
Remove plug from the mains immediately if the
cable is damaged or cut.
Caution: Do not over tighten. Tighten by
hand. Finger tight only.
Electrical safety
#
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Using an extension cable
Always use an approved extension cable suitable for the
u
power input of this tool (see technical data). The extension
cable must be suitable for outdoor use and marked ac-
cordingly. Up to 30 m of HO7RN-F 2 X 1.5 mm² extension
cable can be used without loss of product performance.
Before use, inspect the extension cable for signs of
damage, wear and ageing. Replace the extension cable
if damaged or defective. When using a cable reel, always
unwind the cable completely.
(Original instructions)
Voltage drops
Under certain power supply conditions this product may-
u
cause short-time voltage drops during start-up.
Other equipment may be affected. For example, electri-
u
clights may temporarily reduce in brightness.
Contact the supply authority, if necessary, to determine
u
that the impedance of the power supply is lower than
0.172/0.293 ohms. Disturbances are unlikely to occur under this
condition.
Guard against electric shock
Prevent body contact with earthed or grounded surfaces
u
(e.g. metal railings, lamp-posts etc.). Electric safety can
be further improved by using a high-sensitivity (30 mA/
30mS) Residual Current Device (RCD).
:
Warning! The use of an RCD or other circuit
breaker unit does not release the operator
of your chainsaw from the safety instructions
and safe working practices given in this user
manual.
Features
1. On/off switch
2. Lock-off button
3. Front guard/chain brake assembly
4. Guide bar
5. Chain
6. Chain cover assembly
7. Chain adjust locking knob
8. Chain tension adjustment wheel
9. Chain sheath
10. Power cord
11. Power cord retainer
12. Oil cap
13. Oil level indicator
Assembly
@
Warning! Always wear protective gloves when
working on your chainsaw.
@
Warning! Before performing any assembly
or maintenance on power tools, switch off and
disconnect from mains.
@
Warning! Remove the cable tie that attaches
the chain to the chainbar before assembly.
ENGLISH
9