Black & Decker CS2040 Mode D'emploi page 12

ENGLISH
When supported along its whole length:
Make a downward cut, but avoid cutting the earth as this
u
will blunt your saw chain quickly.
When supported at both ends:
First, cut one third down to avoid splintering and second,
u
cut up to meet the first cut.
When supported at one end:
First cut one third up to avoid splintering and second, cut
u
down to prevent splintering.
When on a slope:
Always stand on the uphill side.
u
When attempting to cut a log on the ground (fig. M):
Secure the workpiece using chocks or wedges. The user
u
or a bystander should not steady the log by sitting or
standing on it. Make sure that the saw chain does not
contact the ground.
When using a saw horse (fig. N):
This is strongly recommended whenever possible.
Position the log in a stable position. Always cut on the
u
outside of the saw horse arms. Use clamps or straps to
secure the workpiece.
Limbing (fig. O)
Removing the branches from a fallen tree. When limbing,
leave larger lower limbs to support the log off the ground.
Remove the small limbs in one cut. Branches under tension
should be cut from the bottom of the branch towards the top to
avoid binding the chain saw.
Trim limbs from opposite side keeping tree stem between you
and saw. Never make cuts with saw between your legs or
straddle the limb to be cut.
Troubleshooting
Problem Possible cause
Lock button not
Tool will not start
pressed.
Front guard in the
brake position
Blown fuse
Tripped RCD
TMains loead not
connected
12
(Original instructions)
Possible solution
Press the lock button.
Reset front guard
Replace fuse
Check RCD
Check mains supply
Problem Possible cause
Chain tension is too
Chain does not stop
slack
within 2 seconds
when the tool is
switched off
Bar/chain appear hot/
Oil tank empty
smoking
Oil hole blocked on
chain bar
Chain tension is too
tight
Guide bar sprocket
nose needs greasing
Chainsaw does not
Chain on backwards
cut well
Chainsaw not using
Debris in tank
oil
Oil hole in cap blocked
Debris in chain bar
Debris in oil outlet
Maintenance
Regular maintenance ensures a long effective life for the tool.
We recommend you make the following checks on a regular
basis.
Warning! Before performing any maintenance on power tools:
Switch off and disconnect the tool from the mains supply.
u
Oil level
The level in the reservoir should not be allowed to fall below
a quarter full.
Saw chain and guide bar (fig. F)
After every few hours of use and before storage, remove
u
the guide bar (4) and the saw chain (5) and clean them
thoroughly.
Make sure that the guard is clean and free from debris.
u
On reassembling, turn the guide bar (4) through 180° ,
u
remove the chain tensioning wheel with a screwdriver and
re-attatch to the opposite side of the guide bar.
Warning! Do not overtighten.
Oil sprocket nose via the sprocket lubriation hole (19), this
u
ensure an even distribution of wear around the guide bar
rails.
Possible solution
Check chain tension
Check oil tank level
Clean oil holes (21 - fig.
E) and clear the groove
around the edge of the
chainbar.
Check chain tension
Oil the guide bar
sprocket nose
Check/modify chain
direction
Sharpen
Empty oil from tank and
replace
Remove debris from
hole
Remove debris and
clean the chain bar
Remove debris