Tools Needed For Assembly - Bosch 4100 Consignes D'utilisation

2610048783.qxp_4100 11/17/17 9:10 AM Page 14

Tools Needed For Assembly

COMBINATION SQUARE MUST BE TRUE
STRAIGHT EDGE OF BOARD
3/4" THICK. THIS EDGE
MUST BE PERFECTLY
DRAW LIGHT LINE ON
STRAIGHT.
FLAT SCREWDRIVER PHILLIPS SCREWDRIVER
BOARD ALONG THIS EDGE.
10 mm WRENCH OR
COMBINATION SQUARE
SHOULD BE NO GAP OR OVERLAP
ADJUSTABLE WRENCH
HERE WHEN SQUARE IS FLIPPED
OVER IN DOTTED POSITION.
Disconnect plug from power source before performing any assembly, adjustment
or repair to avoid possible injury.
14