Using The Rip Fence Pointer When Table Is Not Extended; Using The Table Pointer When Table Is Extended; Making Rip Cuts Beyond 25 Inches Without The Use Of Scale - Bosch 4100 Consignes D'utilisation

2610048783.qxp_4100 11/17/17 9:10 AM Page 34
Attach auxiliary fence 2 to rip fence with two
"C" clamps (Fig. 48).
Feed the workpiece by hand until the end is
approx. 1" from the front edge of the table.
Continue to feed using the PUSH BLOCK 3 on
top of auxiliary fence UNTIL THE CUT IS COM -
PLETE (Fig. 49).
▼ USING THE RIp FENCE pOINTER
WHEN TABlE IS NOT EXTENDED
The rip fence pointer shows the distance
from the blade to rip fence through a conven-
ient viewing and magnifying window.
Align rip fence pointer 4 with lower portion
of scale 5. The lower scale can be used for
widths up to 13.5 inches (Fig. 54).
Fig. 54
6
5
34
Basic Table Saw Operation
7
4
▼ USING THE TABlE pOINTER
WHEN TABlE IS EXTENDED
The upper portion of scale 6 is used for rip
cut 13.5 to 25 inches. Align table pointer 7
with upper portion of scale 6 (Fig. 54).
▼ MAKING RIp CUTS BEYOND 25 INCHES
WITHOUT THE USE OF SCAlE
When positioning fence for maximum rip
without the use of scale, loosen screw 8 and
lower plate 9 below the head 10 of the rip
fence 11 (Fig. 54). DO NOT rip or cut dados
or moldings with the fence beyond this posi-
tion because it cannot be locked.
11
8
10 9