Taurus Alpatec FRESKO 4B Mode D'emploi page 13

or tangled cables increase the risk of electric
shock.
- The appliance is not suitable for outdoor use.
- Do not use or store the appliance outdoors.
- Do not leave the appliance out in the rain or
exposed to moisture. If water gets into the
appliance, this will increase the risk of electric
shock.
- Do not touch any of the appliance's moving
parts while it is operating.
- Avoid all contact with the liquid that could be
released from the battery. In case of contact
with eyes, wash them thoroughly and seek
medical advice. The liquid spilled from the
battery may cause irritation or burns.
USE AND CARE:
- Do not use the appliance if its accessories are
not properly fitted.
- Do not use the appliance if the on/off switch
does not work.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or
jammed and make sure there are no broken
parts or anomalies that may prevent the appli-
ance from operating correctly.
SERVICE:
- Make sure that the appliance is serviced only
by specialist personnel, and that only original
spare parts or accessories are used to replace
existing parts/accessories.
- Any misuse or failure to follow the instructions
for use renders the guarantee and the manu-
facturer's liability null and void.
DESCRIPTION
A Cover bar
B Blades
C Glass lamp
D Lamp holder*
E On/off light button
F STOP fan button
G Timer button
H Speed button
* Only for E27 bulbs, maximum power 60W (bulb
not included).
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
- Ensure that the fan is switched off from the
supply mains before start any installation or
assembly operation.
- Check if you have all the necessary parts.
(Fig.1).
- Remove the motor housing from the packaging.
To avoid any damage on the housing surface,
mount the motor on a soft surface.
- In order to avoid electric shock, make sure
that the power supply has been previously
disconnected.
- The electrical installation must be done in
accordance with the regulations in force, con-
necting the fan to the ground as a precaution
against possible electric shock.
- It is recommended that the installation be done
by a professional.
- Install the fan at a minimum distance of 2,30
meters from the ground or other objects.
ASSEMBLING THE CEILING FAN
- Check "FAN INSTALLATION" at the beginning
of the instruction manual.
- IMPORTANT: To fix the main support to the
ceiling, use the appropriate fixing means for
each type of ceiling.