Stanley D 200/8/6 Manuel Utilisateur page 15

safety.
● When fitting a tool, the flow of air in output must
be switched off.
● When using compressed air, you must know and
2. LAYOUT
1. Shroud
2. Pressure vessel
3. Wheel
4. Supporting foot
5. Quick-lock coupling (regulated compressed air)
6. Pressure gauge (for reading the preset
pressure by means of regulator)
7. Pressure regulator
8. ON/OFF switch
9. Transportation handle
10. Safety valve
11. Receiver condensation drainage tap
12. Pressure gauge (for reading the tank pressure)
13. Axle
14. Clip
15. Bolt
16. Nut
17. Washer
3. SCOPE OF USE
The compressor is designed for generating
compressed air for tools operated by compressed
air.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user/operator and not the manufacturer
will be liable for any damage or injuries of any kind
caused as a result of this.
comply with the safety precautions to be adopted
for each type of application (inflation, pneumatic
tools, painting, washing with water-based
detergents only, etc.).
4. POINTS TO NOTE
WHEN SETTING UP THE
COMPRESSOR
● Examine the machine for signs of transit damage.
Report any damage immediately to the company
which delivered the compressor.
● The compressor should be set up near the
working consumer.
● Avoid long air lines and long supply lines
(extensions).
● Make sure the intake air is dry and dust-free.
● Do not set up the compressor in damp or wet
rooms.
● The compressor may only be used in suitable
rooms (with good ventilation and an ambient
temperature from +5°C to +40°C). There must
be no dust, acids, vapors, explosive gases or
inflammable gases in the room.
● The compressor is designed to be used in dry
rooms. It is prohibited to use the compressor
in areas where work is conducted with sprayed
water.
5. ASSEMBLY AND STARTING
Warning!
You must fully assemble the appliance before
using it for the first time.
5.1 Fitting the wheels (Pic. 3 ÷ 4)
Fit the supplied wheels as shown in Pic. 3 & 4:
● Pic.3a & 3b: Assembly of wheel kit - version A
Assembly by sequence: a, b, c, d, e
● Pic.4a & 4b: Assembly of wheel kit - version B
5.2 Fitting the supporting foot (ref. 4)
Fit the supplied rubber stopper as shown in Pic. 5.
5.3 Voltage
The compressor is equipped with a mains cable
with shock-proof plug. This can be connected to any
230V ~ 50Hz shock-proof socket which is protected
15
G
B