Installing The Dryer; Step 1: Position And Level The Dryer - ALLIANCE D677I Installation/Fonctionnement/Entretien

Installing the Dryer

Step 1: Position and Level the Dryer

Install dryer before washer. This allows room for
attaching exhaust duct.
Install the four rubber feet (in accessories bag).
Select a location with a solid floor. Dryers installed in
residential garages must be elevated 46 cm (18 inches)
above the floor.
B
A
FRONT VIEW
(w/o Closet Door)
Area
Dryer sides and rear clearance
A
Dryer top clearance
B
Dryer front clearance
C
Exhaust duct clearance to combustible
D
material
Weather hood to ground clearance
E
Distance from floor or ceiling to hole edge Not Applicable
F
Area of centered air openings in closet
G*
door
*Louvered door with equivalent air openings is acceptable. (Minimum clearances are shown.)
1 Closet Door
2 Centered Air Openings (G) (2 Openings minimum)
3 Outer Wall of Enclosure
**NOTE: For new installations, locate top of wall vent 106.7 cm (42 inches) above floor to make venting
easier to connect.
512681
1
A C
(Closet Door)
Description
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
No other fuel burning appliance should be installed in
the same closet with the dryer.
The dryer must not be installed or stored in an area
where it will be exposed to water and/or weather.
The dryer needs sufficient clearance and an adequate
air supply for proper operation and ventilation, and for
easier installation and servicing. (Minimum clearances
are shown in Figure 3).
E
D
A
**106.7 cm
(42 in.)
3
SIDE VIEW
Free Standing/Alcove
Installation
0 cm (0 in.)
30.5 cm (12 in.)
Not Applicable
5.1 cm (2 in.)
30.5 cm (12 in.)
Not Applicable
Figure 3
Installation
F
2 (G)
F
FRONT VIEW
D337I
(Closet Door)
Closet Installation
0 cm (0 in.)
30.5 cm (12 in.)
5.1 cm (2 in.)
5.1 cm (2 in.)
30.5 cm (12 in.)
7.6 cm (3 in.)
260 sq. cm/open (40 sq. in.)
D337I
9