Before You Start; Tools; Card Reader Models - ALLIANCE D677I Installation/Fonctionnement/Entretien

Installation

Before You Start

Tools

For most installations, the basic tools you will need
are:
1
5
1 Wrench
2 Screwdrivers
3 Level
4 Teflon Tape
5 Duct Tape
Figure 1
NOTE: An 20.32 cm (8 in.) coin drawer is required
for coin operated MDC and NetMaster models.
8
2
3
4
D818I
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Card Reader Models

The machine is shipped from the factory with the
Electronic Control Diagnostic Harness Assembly
unplugged. To avoid unauthorized manual
programming or vending perform the following steps.
1. Open service door. Refer to Figure 2.
2. Locate diagnostic harness on electronic control.
3. Plug connectors for "white/black" wire and "red/
blue" wire together.
.
1 Service Door
Figure 2
WARNING
Any disassembly requiring the use of
tools must be performed by a suitably
qualified service person.
1
FLW6R
W299
512681