Operating Determinations - EuroLite LAS-7 Mode D'emploi

This product is a so-called showlaser, emitting radiation in a wavelength spectrum between 400 and 700 nm
and producing lighting effects for shows.
Due to the construction of this laser, the beam is moved so fast, that it can only hit the eye very short. This is
why the use of this laser for a Laser-Light-Show can be regarded as save.
Operating a laser product may lead to permanent injury of persons. Please refer to the explanations under
"Legal instructions" and "Protective measures for a safe operation".
Always plug in the power unit least. Make sure that the power-switch is set to OFF position before you
connect the device to the mains.
Keep away from heaters and other heating sources!
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
Never direct the laser beam to people or animals.
CAUTION LASER DIODE: never unscrew the housing!
Never leave this device running unattended.
Never look directly into the light source, as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!
Always disconnect from the mains when the device is not in use or before cleaning it.
Keep away children and amateurs from the device!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.

3. OPERATING DETERMINATIONS

Areas of use
This device is designed for professional use, e.g. on stages, in discotheques, theatres etc.
This laser must only be used for shows. The operation of a class 3R showlaser is only allowed if the
operation is controlled by a skilled and well-trained operator.
This device is designed for mobile use and for permanent installations.
Laser effects are not designed for permanent operation. Consistent operation breaks will ensure that the
device will serve you for a long time without defects.
This product was designed for indoor use only.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
The protections must only be proyected in the blocked showlaser area. Please refer to the explanations
under showlaser area.
HEALTH HAZARD!
17/49 51741140_V_1_0.DOC