Technical Specifications - EuroLite LAS-7 Mode D'emploi

The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
Always disconnect from the mains when the device is not in use or before cleaning it.
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
Clean the front glass every two weeks from dust and smoke fluid residues.
There are no servicable parts inside the device. Never open the housing! Maintenance and service
operations are only to be carried out by authorized dealers.
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.

8. TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
Maximum optical power:
Laser classification:
Wavelength:
Dimensions without bracket (LxWxH):
Weight:
Please note: Every information is subject to change without prior notice. 08.02.2005 ©
LAS-7
via power unit 9 V DC, 300 mA
3 W
<5 mW
3R
635 - 670 nm
140 x 170 x 110 mm
0.4 kg
26/49
LAS-8
via power unit 9 V DC, 600 mA
5 W
<5 mW
3R
532 nm
140 x 170 x 110 mm
0.5 kg
51741140_V_1_0.DOC