Publicité
Les langues disponibles
Les langues disponibles
DE
GB
INTRODUCTION
FR
Please read this manual before carrying out any operation.
It is compulsory to read this instruction manual before starting any
NL
kind of action.
The proper operation and full compliance of this product's
ES
performance is guaranteed only if all the instructions provided in this
manual are closely adhered to.
IT
We guarantee that this product complies with the technical
specifications described in this manual.
The manufacturer shall not be held responsible for any improper uses
PT
other than those described herein.
Use protective work gloves, protective footwear, hard hat and safety
PL
goggles.
Misuse:
DA
-
This product should only be used as described in this
documentation; any other use is considered improper.
-
The manufacturer accepts no responsibility for any damage
EL
caused by the incorrect or unreasonable use of the
equipment.
-
Moreover, misuse shall also void the warranty.
Take care of your tools:
-
Be sure to store your tools in a clean state.
-
Place the tools inside their original package.
INTRUDUCTION & SPECIFICATION
Fast and simple compression of valve springs. Precision made, light
weight aluminium yoke and smooth-acting pneumatic ram make
light work of valve spring removal - especially on modern multi-valve
engines. Time savings of between 60 and 70% have been achieved
using this tool.
TECHNICAL DATA
Min - Max Compression
Force:
Throat Depth:
Jaw Opening:
Pressure feet:
10
METHOD OF PREPARATION
6bars (87psi) =75kg (165lb)
10bars (145psi) =100kg (220lb)
170 mm
330 mm
Ø19,8 - Ø23,5 - Ø34 mm
TECHNICAL DATA
Spring Adaptors:
PREPARING COMPRESSOR FOR USE
AIR SUPPLY
Recommended hook-up is shown below.
WARNING! Ensure the air supply is clean and does not
exceed 116 psi while operating the compressor. Too high an
air pressure and/or unclean air will cause excessive wear,
and may be dangerous, causing damage and/or personal
injury.
Ensure that the compressor's air valve (or throttle) is in the "off"
position before connecting to the air supply.
You will require an air pressure of 8 bar (116 psi).
Drain the air tank daily. Water in the air line will damage the grinder
and invalidate your warranty.
Clean air inlet filter weekly.
Line pressure should be increased to compensate for unusually long
air hoses (over 8 metres). The minimum hose diameter should be
1/4fl I.D. and fittings must have the same inside dimensions.
Keep hose away from heat, oil and sharp edges. Check hoses for
wear, and make certain that all connections are secure.
OPERATION
VALVE SPRING REMOVAL
Select valve remover and bush to suit the valve spring seat and
attach to the spring compressor using the 2 screws provided (fig 1).
Loosen cylinder clamp screw and connect air supply to control
valve.
Ø24,5 - Ø25 - Ø27 - Ø29 - Ø32 -
Ø34 - Ø41 - Ø50 mm
Publicité
