Melitta bar-cube cw Mode D'emploi page 17

5. Installation
Customer service will set up, install and present the
device ready for operation.
❍
You should leave changes on the installation or
setup only to customer service because of the
associated hazards.
❍
Make sure that the following requirements are
met before using the machine; the safe and
flawless operation depends on them.
a) Requirements on the electrical connection
– The supply voltage must match the
specifications on the type plate.
– The supply line must be fuse-protected in the
building using a ground fault circuit
interrupting (GFCI) switch (max. 30 mA).
b) Requirements on the installation location
❍
The device may only be used in closed dry rooms
and not outdoors! Humidity and temperature
effects may impact the function and safety.
– The device must be level. Adjustable bases are
available for alignment on slightly uneven
surfaces.
c) Requirements on the personnel
– Any identified malfunctions or damages need to
be checked first by Customer Service and, if
necessary, rectified, before the machine is put
back into use.
– The device may only be operated by persons
familiar with the generally common care when
handling heat-generating household appliances.
The device may not be used unsupervised or
without instructions by children or persons unable
to safely use the device because of their physical,
sensory or mental abilities or their lack of
experience or subject knowledge.
d) Requirements on the operation
– Apparent malfunctions or damages must first
be inspected by customer service and possibly
be serviced before the device may be used
again.
– The inspection legally required by commercial
operators of the system every 4 years by an
authorized professional for proper condition must
be performed and documented. This can be done
by customer service and certified (no additional
inspection is required before the initial startup).
6. Safety instructions
❍
Never open any of the casing parts or covers,
unless instructed to do so. There is danger of
electrocution or being injured by hot parts, when
parts of the casing or covers are opened.
❍
Protect the machine from humidity! There may
be danger to life through electrical shock if water
reaches device parts other than those specifically
intended for contact with water. Especially, do not
operate the device ...
– outdoors.
– never hose it off with water, for example,
using a hose or high-pressure cleaner.
❍
Do not continue using the device if damages
are visible or apparent malfunctions occur.
Important safety functions may malfunction in this
case. Have them first inspected and repaired, if
required, by customer service, for example
– if the housing is damaged or covers do not
close properly,
– if the power cord or power plug are
damaged or if the fuse for the circuit of your
system trips repeatedly,
– If you detect unusual odor development or
heat development on the device (the housing
is normally only warm to the touch during
operation except for the heated stainless steel
bottoms).
Pull the plug from the outlet in all these cases
or trigger the fuse for the circuit. Then notify
customer service.
5
GB