Publicité
Les langues disponibles
Les langues disponibles
To change the by-pass screw, unscrew completely the screw located on the left of the tap
and replace it by corresponding screw. For a use in natural gas, change the injectors
(burner + pilot light (Ø 45). They are delivered in a small plastic bag in the package. Un-
screw completely the nut and then the injector located on the hole. The low flame of the
appliance is regulated by unscrewing the by-pass screw to obtain a flow of 6KW.
Air adjustment
Injectors were conceived to avoid any air adjustments and that whatever the gas you use.
c) Use of device :
Elements of command and display
Command/Display
Power control knob
(n°1 on picture)
Pilot light (n°2 on pic-
ture)
Switching-on
Press the power control knob (n°1 on picture) for a few seconds in front of star posi-
tion.
Use a gas lighter or a long matchstick by holding it near the pilot light (n°2 on picture)
Keep the control knob (n°1 on picture) pressed for some more seconds.
The burner then remains lit and it is now possible to increase the power by turning the
power control knob (n°1 on picture).
Temperature setting
Once the burner is lit, set the appliance to the desired power by turning the control
knob (n°1 on picture).
It is not necessary to leave the device switched on at full power. It is necessary to
adapt the temperature to products to be cooked to limit the gas consumption.
Stopping the appliance
Set each control knob (n°1 on picture) to 0: the appliance is completely switched-off.
Cut the gas supply
Clean the appliance. (See 6. Cleaning)
d) Breakdown / repair:
In case of breakdown or of damaged part, please call your after-sales service and confide
any technical operation to qualified person.
Function
On/off
Set the power (low flame = low power, high flame = high pow-
er)
Switch on the machine
19
Publicité
