Table des Matières
Publicité
installation guide
Always use two people when setting up the base.
STEP 1
Place the bed base box in a desired location with the bottom of the box
facing up .
Remove the binding straps and packing materials, making sure not to
puncture the box with any sharp objects .
STEP 2
Remove the bed base from the box keeping the bottom of the base facing
upwards .
8
For customer support, visit www.ergomotion.com or call: US 1-888-550-3746
STEP 3
To install headboard brackets: See detailed installation
instructions on page 16.
To install the legs, thread the washer over the bolt of the leg with the
recessed side facing the leg, and tighten by hand . Do not over tighten.
STEP 4
To sync two bases with the SmartSync
Uncoil the Power Down Box from the frame and
install (2) 9 Volt batteries (not included) .
Place box on the ground . Ensure that it is easily
accessible when the base is turned to its upright
position .
cord, see page 14.
™
Publicité
Table des Matières
