Clarke MA50 15B Mode D'emploi page 8

A - ENGLISH
BATTERY CHARGING
NOTE
Charge the batteries when the yellow or red indicator, (51) or at the end of every work cycle.
CAUTION !
Proper battery care will extend battery life
If the machine is not equipped with on-board battery charger, choose an external battery charger suitable for the type of batteries
installed.
WARNING !
Please use Clarke approved charger to charge the batteries.
1. Place charger and machine in a well-ventilated area.
2. Turn machine off.(47)
3. Remove the recovery tank,(2) exposing battery compartment.
4. Plug the charging cable to the grounded wall outlet (100v~240v). Connect the charging cable to the machine socket.
5. The charging light (30) indicates the batteries are charging. A green light indicates battery charging is completed.
6. Upon the completion of charging, fi rst unplug the charging cable from the wall outlet and then disconnect from machine.
7. Replace the recovery tank.
NOTE
For further information about the operation of the battery charger, (29) see the charger section.
SQUEEGEE CLEANING
NOTE
For optimal performance, the squeegee blades must be clean, dry and undamaged.
CAUTION !
It is advisable to wear protective gloves when cleaning the squeegee because there may be sharp debris.
SQUEEGEE BLADE CHECK AND REPLACEMENT
1. Take off the squeegee as shown in the previously.
2. Check the edges of the front & rear blades for cracks. If necessary replace with new blades.
3. Unscrew six the thumb nuts (37) to remove the blades.
4. Check the front & rear blades for cuts and tears. If damage is found, you can fl ip the blades once & re-install. If already fl ipped, please
replace with new blades.
5. Install the squeegee in the reverse order of removal.
A - 8
INSTRUCTIONS FOR USE
MA50 15B - 56091128 7/2014