Adjusting The Spring Preload - Betamotor EVO 2T EUROPA Mode D'emploi

3
ADJUSTING THE SPRING
PRELOAD
To adjust the spring preload, use the pro-
cedure described below.
Loosen counter-ring 1, rotate ring 2 clock-
2
wise to increase the spring preload (and
consequently the shock absorber preload)
1
or anticlockwise to decrease it.
After obtaining the desired preload, turn
counter-ring 1 until it stops against adjust-
ing ring 2.
For standard calibration, refer to page 11.
NOTE: for movement of the rings use a
specific sector key with square pin.
ATTENTION! Do not move the screw 3
under any circumstances.
3
EN
33