NATURAL GAS
1. This barbecue is designed for use with natural gas.
Do not use with liquid propane (bottled gas). The
valves, orifices, and hoses are for natural gas only.
2. Do not use with charcoal.
3. A shut off valve must be used on the gas supply piping
system.
4. When the appliance is not in use, turn off the natural
gas supply at the shut off valve.
5. The appliance is designed to operate at a regulated
pressure of 7 inches water column (W.C.).
STORAGE
1. The gas must be turned off at the natural gas supply
when the barbecue is not in use.
2. When the barbecue is stored indoors, the gas supply
must be disconnected.
GAS SUPPLY TESTING
1. The outdoor gas grill and its individual shutoff valve
must be disconnected from the gas supply piping
system during any pressure testing of that system at
test pressures in excess of 1/2 psig (3.5kPa).
2. The outdoor gas grill must be isolated from the gas
supply piping system by closing its individual manual
shut off valve during any pressure testing of the gas
supply piping system at test pressures equal to or less
than 1/2 psig (3.5kPa).
GAS SUPPLY HOSE
1. On models supplied with an extension hose, the hose
assembly is specifically designed for your model. No
modifications or additions should be attempted. Hose
and hose couplings comply with CGA Standard CAN
1.83.
2. On models equipped with the "quick disconnect"
coupling, close "shut off valve" before disconnecting
coupling.
3. "Quick disconnect" coupling must be kept clean and
free of dirt and debris.
4. Protect the hose from dripping grease and do not allow
the hose to touch any hot surface, including the base
casting of the barbecue.
5. Inspect the hose at least once per year. If the hose is
cracked, cut, abraded or damaged, the appliance must
not be used.
6. For replacement of hose assembly, contact your
dealer or approved service centre.
A.
GAS SUPPLY PIPING
B.
QUICK DISCONNECT COUPLING
C.
ADAPTER FITTING
D.
EXTENSION HOSE ASSEMBLY
3