ARIETE Moka aroma 1337 Mode D'emploi page 13

descrIpTIon oF The ApplIAnce
A - Machine body
B - Cup-resting grill
C - Drip tray
D - Power cord + Plug
E - Maxi Cappuccino attachment and wand for water and
steam supply
F - Water tank
G - Filter holder for ground coffee
H - Thermocream® Disc
I - Perforated silicone disc
L - Thermocream® Filter
M - Coffee measure/presser
Identification data
The following machine identification data are shown on the plate placed underneath the machine's standing base:
• manufacturer and CE mark
• model (Mod.)
• serial number (SN)
• electrical supply voltage (V) and frequency (Hz)
• absorbed electric power (W)
• assistance toll-free number
Always give the model and serial number to the Authorised Service Centres when requesting assistance.
prelImInAry phAses For use
using the appliance for the first time
Check that the voltage of the domestic network is the same as that indicated on the technical information plate of the appli-
ance. Place the appliance on a stable surface.
Open the tank lid (Z). Fill the tank up to the level marked MAX (Fig. 3).
While filling, pay close attention that the water does not dampen the switch area to prevent infiltrations inside the electrical
parts.
Insert the plug into the socket, which must be earthed.
starting the first time
After having filled the tank with cool tap water, start the machine by pressing the button (O). Indicator lamps (N) and (S)
turn on to indicate that the machine is on and that the internal boiler has started to heat up, respectively. Press the coffee
dispensing switch (R) until you see water come out of the filter holder seat (Fig. 4).
if you are starting the machine for the first time or after a period of time during which it has not been used, it is
recommended that at least one cup of water be allowed to pass through the boiler's hydraulic circuit. also open
the cock (p) by slightly turning it anti-clockwise after having placed a container underneath the maxi Cappuccino
device wand (e).
Then close the cock (P) by turning it clockwise, and press the coffee dispensing switch (R) to make the water stop coming
out. The machine will be ready to make coffee when the indicator lamp (S) turns off.
hoW To mAke coFFee
Put the Thermocream® Disc (H), the perforated silicone disc (I) and the Thermocream® Filter (L) into the filter holder in the
order indicated (Fig. 5). Measure out the coffee in the filter and lightly press with the specially provided presser: completely
fill two measures for two cups of coffee, and fill only one for one cup. Insert the filter holder into its seat.
Warning!
Tighten well by turning it from left to right while making sure you have hooked it properly onto the flange (Fig. 6).
If too much ground coffee is put inside the filter, turning the filter holder may prove difficult and/or you may get leaks
from the filter holder when the coffee is being dispensed.
Check that the steam function button (t) has not been unintentionally pressed.
It is advisable to let the filter holder heat up a few minutes in its seat before making a cup of coffee so that the first cup is
N - "On" indicator light
O - On-off switch
P - Steam dispensing cock
Q - Coffee dispensing indicator lamp
R - Coffee dispensing switch
S - Boiler temperature indicator lamp
T - Steam function switch
U - Pod filter holder
V - Pod filter
W - Drain pan
Z - Tank cover
13