ARIETE Miro 1338 Mode D'emploi page 11

the machine corresponds to the local mains voltage.
• The use of extension leads, which have not been authorised by the appliance manufacturer, may cause damage and
accidents.
• Before filling the tank with water, remember to always disconnect the appliance at the socket.
• If the electric cable is damaged it must be replaced by the manufacturer or its Technical Assistance Service, or in any case
by a person with similar qualifications, in order to avoid any risk.
• Never let the live parts come into contact with water: this may cause a short circuit
• Unplug before any cleaning or maintenance operations.
• Do not immerse the appliance in water or other liquids.
• Always turn off the appliance and remove the power cable plug from the socket-outlet before filling the tank with water.
• Do not lift the appliance by grasping its water tank or its tray, but only by grasping its body.
• Choose a sufficiently well lit and clean environment, with an easily accessible electric socket.
• Avoid putting excessive quantities of water into the tank.
• Never leave the appliance unattended when it is connected to the power supply.
• The appliance must be used and rested on a stable surface.
• The appliance is not to be used if it has been dropped, if there are visible sign of damage or if it is leaking. Do not use
the appliance if the power cord or the plug are damaged, or if the appliance is faulty. To prevent any accident, all repairs,
including the replacement of the power cord, must be carried out by an Authorised Service Centre or, in any case, by
qualified personnel.
• Never direct the steam or hot water jet towards parts of the body; handle the steam spout with care: risk of scalding!
• The outer metallic parts of the appliance and of the filter holder must not be touched with the appliance in operation,
because it could cause burns.
• If water does not come out of the filter holder, it may be because the filter is clogged. In this case, remove and disconnect
the filter slowly because any remaining pressure can cause spillage or splashing. Then clean as explained in the relevant
paragraph.
• Place the machine on a stable surface where it cannot be knocked over.
• Never use the machine without water because the pump will burn out.
• Never fill the water tank with hot or boiling water.
• Do not place the machine on very hot surfaces or near open flames in order to prevent damage to the body.
• The cable must not touch any hot parts of the machine.
• Do not use sparkling (carbonated) water.
• Use only pods that show the E.S.E. standard brand.
• Never put substances other than coffee powder in the filter (A). They could cause serious damage to the appliance.
• Do not leave the machine at a room temperature below 0°C because the water remaining in the boiler could freeze and
cause damage.
• Never use the appliance outdoors.
• Do not expose the appliance to atmospheric agents (rain, sun ...).
• Before cleaning the appliance always unplug it and allow it cool down. Clean only with a non-abrasive cloth that has been
slightly dampened with water, adding a few drops of mild, non-aggressive detergent (never use solvents that damage
plastic).
• sAve These InsTrucTIOns fOr fuTure reference
Danger of damage originating from other causes
Warning of burns
Warning – material damage
11