4. Make sure you leave enough cable to be able to remove the projector to the edge of the pool in the event of an anomaly.
(Fig. 2)
Prefabricated swimming pools / Spas
1. Using a hole drill bit, make a circular hole 42 mm. in diameter in the wall (Fig. 3).
2. Place the projector inside the pool, with the flat joint and screw the 1"¼ GAS washer through the outside of the pool
(Fig. 4).
Attention:
• Always install the body in order an easy manipulation from the outside, or in one way that you can extract it out without
many difficulties.
• Before any handling ensure that there is NO voltage supplied to the projector.
Take the precaution of leaving 1.5 m of cable wound on the body of the projector in order to be able to remove the projector
to the edge of the pool in the event that handling is required (Fig. 5).
5. MAINTENANCE:
This projector does not require any type of maintenance. If the projector is not working properly, please contact our cus-
tomer attention department.
THIS PRODUCT DOES NOT CONTAIN ANY ELEMENTS THAT CAN BE HANDLED, DISMANTLED OR REPLACED BY
THE USER. IT IS FORBIDDEN TO ACCESS INSIDE THE PRODUCT, OTHERWISE THE GUARANTEE OF THE PRODUCT
6. SAFETY WARNINGS:
• People in charge of assembly should be suitably qualified for this type of work.
• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING SWIMMING
POOLS.
• All maintenance operations should be performed with the projector disconnected from the Mains.
7. ASSEMBLY AND FUNCTIONING WARNINGS:
• It is not recommended the use of sealing putty in this product and, anyway, you should use only products specifically
conceived to work with ABS, all those products of universal use remain excluded.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric compo-
nents which have been inserted or handled at locations other than its own premises.
• It is responsibility of the installer to ensure that no water gets inside the projector by means of the cables.
• This projector is not designed to work submerged in seawater.
• This projector is resistant to pool treatments described below, always that the concentration values do not exceed the
following levels:
Chlorine
Bromine
Salt electrolysis (Na Cl)
Attention : Please note that the Ph of pool water always must be between 7.2 and 7.6.
WILL BECOME INVALID.
TYPE OF TREATMENT
CONCENTRATION IN WATER
2 mg/l
5 mg/l
6 g/l
4