Battery - VISIOMED EASYSCAN FTX3 Manuel D'utilisation

M M
EMORY ODE
1. Press M key in clock mode to enter into memory mode
2. "- " will be displayed if no data is stored
3. Maximum storage is 20 sets of data with date and time
shown and temperature type (frontal or axillary)
4. Press M key for data scroll
5. Press T key to read data
Note:
- Unit returns automatically to standby mode 30 seconds after last
key pressed
- Press any key to stop any active vocal announcement.
- The vocal reading will automatically turn off the blue backlight
B
ATTERY REPLACEMENT
Remove the battery compartment cover. Use only new
batteries.
Replace the battery compartment cover after battery
replacement (1 button cell battery CR2032).
M
AINTENANCE
M :
AINTENANCE
1. Remove any stains on the apparatus with a soft and dry cloth.
2. Clean the probe tip as follows: very gently wipe the surface with a cotton
swab or soft cloth moistened with clinical alcohol, after the alcohol has
completely dried out, you can use the thermometer.
3. Don't wash with water or detergent containing abrasive or benzene.
S :
TORAGE
1. Clean the thermometer and put the cover on to protect the lens after each
use.
2. Don't leave the thermometer exposed to direct sunshine, high temperatures,
dampness, fire, flames, vibrations or impact.
3. Remove the battery if not used for long periods.
C :
ALIBRATION
This thermometer is calibrated at the time of manufacture. If the thermometer is
used according to the instruction, periodic recalibration is not required. If at any time
you question the accuracy of the measurement, please contact the retailer
immediately.
Don't attempt to modify or reassemble the thermometer.
Visiomed – EasyScan – User Manual V.4-102008
:
,
STORAGE AND CALIBRATION
23/39