Witter BM46U Instructions De Montage

MATERIALS:
A 1 Main Crossbar
B 1 Neck option
D 2 M8 x 25mm bolt, washer and Nyloc nut
Existing M12 Nuts(M12 Grade 10.9 – 120Nm) & M12 Washers 30 o.d. and 40 o.d
X 4
E 1 Electrical Plate Bracket
FITTING:
1. Remove bumper-
Remove screws securing bumper along lower edge, wheel arches and bumper tips, open the boot and remove the
plastic/rubber light cluster shut panel trim to reveal 1 screw along top edge of bumper.
2. Starting at bumper tips, carefully pull bumper outwards to release from clips along side panel. Repeat on other side and
then pull the whole bumper rearward to release from the clips along rear panel. Disconnect any sensor wiring.
3. Release rear most exhaust hangers and remove the crash beam, retaining the plastic trim panel. Hand the beam
back to the customer.
4. Attached Main crossbar (A) to the vehicle using original nuts and Washers provided (X), 40mm washer on lower fixing
(liquid thread lock recommended).
5. Attach exhaust hangers to Main crossbar using Bolts (D).
6. Attach plastic trim panel to Main crossbar (A) using original push clips (4 off).
7. Attach chosen Neck Kit (B) and Electric plate (E) as per separate instructions.
8. Fully tighten all fixings to their correct torque settings.
9. Cut aperture in lower bumper tray following perforated lines.
10. Re-fit the bumper, remembering to attach wiring for any sensors. Take care to ensure bumper locates between clips
on rear panel correctly otherwise bumper may be damaged when boot is shut.
Recommended torque settings: Grade 8.8 bolts: M8 – 27Nm, M16 - 200 Nm Grade 10.9: M12 – 120Nm
Fitting
Instructions
W 0 0 0 1 B M 4 6 U - F IT $ 0 1 1 5 0 3 3 0 0 0 0 0
UNIVERSAL TOWBAR FOR:-
For use with xxx7 series necks
#NAME?
BM46U
BMW 5 SERIES G3x