Recycling The Machine; Maintenance; Regular Servicing And Inspection - MIRKA 1230 M Mode D'emploi

An optional case fastening accessory with attachment system can be installed on top of the machine for fastening of
2-point or 4-point storage cases . Unplug from the socket before installing the case fastening accessory .
CAUTION
Do not lift machine and case fastening accessory without ensuring that the storage case is safely installed . Note the
weight and balance of the appliance in case of storage . Maximum weight of storage cases is 30 kg .

4.5 Recycling the machine

Make the old machine unusable .
1 . Unplug the machine .
2 . Cut the power cord .
3 . Do not discard electrical appliances with regular household waste .
As specified in European Directive 2012/19/EU on old electrical and electronic appliances, used electrical
goods must be collected separately and recycled ecologically .

5. Maintenance

5.1 Regular servicing and inspection

Regular servicing and inspection of your machine must be carried out by suitably qualified personnel in accordance
with relevant legislation and regulations . In particular, electrical tests for earth continuity, insulation resistance, and
condition of the flexible cord should be carried out frequently .
In the event of any defect, the machine MUST be withdrawn from service, completely checked and repaired by an
authorized service technician . At least once a year, a Mirka technician or an instructed person must perform a technical
inspection including filters, air tightness and control mechanisms .
5.2 Maintenance
Remove the plug from the socket before performing maintenance . Before using the machine make sure that the
frequency and voltage shown on the rating plate correspond with the mains voltage .
The machine is designed for continuous heavy work . Depending on the number of running hours – the dust filter
should be renewed . Keep the machine clean with a dry cloth, and a small amount of spray polish .
During maintenance and cleaning, handle the machine in such a manner that there is no danger to maintenance staff
or other persons . In the maintenance area:
• Use filtered compulsory ventilation .
• Wear protective clothing .
• Clean the maintenance area so that no harmful substances get into the surroundings .
During maintenance and repair work all contaminated parts that cannot be cleaned satisfactorily must be:
• Packed in well-sealed bags .
• Disposed of in a manner that complies with valid regulations for such waste removal .
For details of after sales service, contact your dealer or Mirka service representative responsible for your country . See
reverse of this document .
Mirka® Dust Extractor • 1230 M • 230 V / 100–120 V • PC & AFC
en
97