Telcoma Automations T 200 Instructions D'utilisation page 55

GB TAB.1
MOR. MOR.
n. n.
1
2
3
2 3
4
5
6
5 6
7 8
9 8
10 11
12 13
14 15
15 16
17 18
20 19 o 25 N.C. contact
21 19 o 25 N.C. contact
22 19 o 25 N.C. contact
23 19 o 25 N.C. contact
24 19 o 25
26 25 o 31
27 25 o 31 N.C. contact
DEVICE V
Motor M1
230Vac
Motor M1
230Vac
Motor M1
230Vac
Capacitor
230Vac
Motor M2
230Vac
Motor M2
230Vac
Motor M2
230Vac
Capacitor
230Vac
Flashing light
230Vac
Light
230Vac
Line
230Vac
Auxiliaries
24Vac
Photocell/s
24Vac
transmitter
Warning light
24Vac
Electric lock
12Vcc
N.C. contact or
N.O. pushbutton
N.C. contact or
N.O. pushbutton
I
FUNCTION
max
4A Common M1
4A Close M1
4A Open M1
4A Motor breakaway M1
4A Common M2
4A Close M2
4A Open M2
4A Motor breakaway M2
Movement
1A
indicator
1A Courtesy light
C. unit power
6,3A
supply
150mA Power supply
Transmitter power
150mA
supply for foto-test
100mA Gate open
1A Mechanical lock
Closing limit
switch (M1)
Opening limit
switch (M1)
Photocell 1**
Photocell 2**
Jolly 2
Jolly 1
Fixed safety edge
NOTES
The motor M1 is delayed for gate clo-
sing (to cut out the delay, see dip-
switch No. 11). In swing gate installa-
tions the motor M1 should control the
leaf with the electric lock.
See motor notes
The motor M2 is delayed for gate
opening (to cut out the delay, see dip-
switch No. 11)
See motor notes
On when the motor is working. Switching
on may be anticipated (pre-blinking), see
dipswitch No. 5 functions
On, from start of movement to 3
minutes after full closure
Connect to the 230Vac line. See
"ELECTRICAL CONNECTIONS"
Permanent for photocells and auxilia-
ries power supply
Power supply for photocell transmitter
(if the Foto test function is used)
Use a 24V 2W max. bulb, see text
Active for a few seconds at every
start of opening
Connect this input if not used to the
common terminal.
Connect this input if not used to the
common terminal.
During closure it reverses the direc-
tion. Connect this input if not used to
the common terminal
Temporary stop during opening. During clo-
sing it reverses the direction. Connect this
input to the common terminal if it is not
used.
See dipswitch No. 3 and 4 functions.
If this input is not used, put dipswit-
ches 3 and 4 to OFF.
See dipswitch No. 3 and 4 functions.
If this input is not used, put dipswit-
ches 3 and 4 to OFF.
Reverse the direction for a few seconds and
the control unit locks. Connect this input to
the common terminal if it is not used.
51