Preparation; Initial Cleaning Of The Device; Choosing The Location - Steinbach Classic 310 Notice Originale

There is a higher risk of damage to the device if it is stored or
transported without the packaging.
- Do not dispose of the packaging.
- In the case of damage, substitute the packaging with an at least
similar box.
Checking the delivery for completeness and damage
1. Open the packaging carefully.
2. Take all parts out of the packaging.
3. Check the completeness of the delivery.
4. Check the delivery for damage.

Preparation

Initial cleaning of the device

1. Remove the packaging materials and all protective foils if present.
2. Clean all parts of the package content as described in the "Cleaning" section.
The device has been cleaned and is ready for use.

Choosing the location

The filter system is sufficiently protected from water penetration and foreign
objects. We nonetheless recommend choosing a site that is protected from
the weather.
- Position the filter system between the suction opening and the injection nozzle.
- Position the pump below the pool's water level.
- Ensure sufficient distance to the pool wall so that the filter system cannot be used as
an aid for entering the pool.
- Make sure that the maximum distance of 2 meters to the pool is not exceeded.
- Install the filter system on a solid base such as a large concrete patio stone. Use a
spirit level
35
Product dimensions:
46
to make sure it is level.
NOTICE!