Mirage OmniVibe Notice D'utilisation page 10

SYMPTOM
No sound from
speakers.
Crackling sound
from speakers.
Sound is distorted.
Sound is distorted
(when connected to
PC or laptop).
Radio interference.
Remote Control
doesn't work.
10
POSSIBLE PROBLEM
Problem with audio source. Test the speakers on another audio
Bad connection.
A problem with your audio
source.
Volume level on OmniVibe
is set too high.
Sound source is distorted.
Check the EQ setting on
your iPod or source device.
Volume level in operating
system is set too high.
Too close to a radio tower.
Low battery.
Remote Control is not
pointed toward the
OmniVibe's IR window.
o w n e r s m a n u a l
SOLUTION
source by removing the 3.5mm stereo
cable from the audio source and
connecting it to the "line-out,"
"audio-out" or the headphone jack of
a different audio source (e.g., CD player,
MP3 player).
Check connection if iPod is in the
docking station. Check connection of the
3.5mm stereo cable. Make sure it is
connected to "line-out," "audio-out," or
the headphone jack on your audio
source – and NOT "speaker-out."
Unplug the 3.5mm stereo cable from the
audio source. Then plug it into the
headphone jack of an alternate source
(e.g., CD player, MP3 player).
Press the "–" button on the OmniVibe
or the wireless remote control to
decrease the volume.
WAV and .MID files are often of poor
quality; therefore distortion and noise are
easily noticed with high-powered
speakers. Try a different audio source
such as a music CD.
For optimal sound quality is is
recommended that the source device EQ
be set to Flat or OFF.
Check the operating system volume level
and decrease if necessary.
Move your speakers to see if the
interference goes away.
Replace battery.
Point the Remote Control toward the
IR window (right of the MIRAGE
within 15 feet of the unit.
® logo),