Publicité
Les langues disponibles
Les langues disponibles
COMFORT
Position the assembly seal around the cut and
3
in lower part of the evaporation unit, as shown in
photo. Seal the inside with silicone.
3
Mount the evaporation unit from the outside and
4
from the inside, aligning it on the cut in the roof.
Mount the frame, securing it with (4) self-tapping
5
screws and mount the (2) attachment supports
with (4) M6/100x60 studs, using flat washers
and nuts on the frame and evaporation unit
boreholes.
Secure the duct unit to the (2) supports with (4)
6
M4/70x10 screws and pass through the cables.
Connect the cables to the front and secure the
front with windows on the previously mounted duct
unit using (4) M4/70x15.
Silicone
3
5
6
13
EN
4
5
Publicité
