Yakima 8007078 Mode D'emploi page 2

BEFORE YOU BEGIN
Tools must be installed head to the rear.
• Axe mounts blade up.
• Shovel must clear
crossbar and
curve away from you.
Snap 2 larger clamps
around the upper tube on
either side of the 1/2"
vertical tube.
Insert and tighten screw using
wrench to stabilize locknut.
1033041B-2/9
• Determine the best spacing for
Attach back plate.
• Insert spacers.
• Insert screws.
• Do not tighten
completely.
Tighten all screws.
brackets.
Pry apart smaller clip and
attach at base of vertical tube
flat side to front.
Install front plate into
front slot.
NOTE: Install brackets a
minimum of 3 spaces apart
and not over a joint.
Repeat
installation
for second
bracket.
INSTALL
BRACKETS A
MINIMUM OF 3
SPACES APART
AND NOT OVER
A JOINT.