SATA UBE Mode D'emploi page 5

6. Warranty Terms
During the period of twelve (12) months from the date of original
purchase SATA will repair or, replace the product without charge
for parts or labour subject to the following conditions.
The warranty covers the value for production parts or defects
in material during the warranty period. The warranty does not
include damages caused by improper handling, normal wear
and tear, mechanical damages, faulty assembly, improper main-
tenance, unusual spray materials substitute materials, chemicals
such as alkaline solutions and acids, electro-chemical or electric
influences, as far as this damage is not the result of any error
committed by us. Abrasive spray material such as red lead and
liquid grinding material etc. reduce the lifetime of valves, pack-
ings, guns and nozzles. Wear and tear damage caused by this
are not covered in this warranty. Units should be inspected upon
delivery by the consumer. Obvious damage must be reported
within 14 days of receipt of the unit to the supplier to avoid loss
of the right to claim notice of defects.
Additional claims such as compensation are excluded. This
refers as well to damages caused during meetings , training
sessions, or demonstrations.Should the consumer require imme-
diate repair or replacement before a determination of whether
the affected unit is covered by the warranty, the repair or the
replacement will be made and charged at the current prices. If it
is determind that the item is covered by the warranty, a credit will
be issued for the repair or replacement. Replaced parts become
the property of SATA or their distributor.
Notice of defects or other claims do not entitle the consumer to
delay or refuse payment.
Returned merchandise to SATA must be sent prepaid. All service
charges, freight and handling charges are to be paid by the con-
sumer. The charges made will be in line with currently existing
pricing. Suretyships may not prolong the warranty period. This
warranty terminates upon unauthourised inference.
Warning! Attention!
When using solvents and cleaning agents based on halogen-
ated hydrocarbons e.g. 1.1.1-trichlorethylene and methylene
chloride, chemical reactions can occur on the aluminium cup,
gun and on galvanized components (small quantities of water
added to 1.1.1-trichlorethyelene produce hydrochloric acid).
This can cause oxidation of the components; in extreme cases,
the reaction can be explosive.
Therefore only use solvents andcleaning agents for your paint
gun which do not contain the substances named above. You
must never use acid, alkaline solutions / Iye or stripping agents
for cleaning.
7. Spare Parts
Art. No. Description
4788 Trigger
11098 Packing
11437 Closing screw
12864 Spray pipe
26054 Compression spring
53082 O-Ring 12 x 1.5 mm
53942 Air connection piece
65979 Air piston rod
65987 Trigger spigot
65995 Ascending pipe
66001 Nozzle
3426 Safety washer
SATA UBE | 5
EN