Powerbank/Rechargeable Battery - Unold 86870 Mode D'emploi

1. Before assembling, ensure that you are assembling the appliance in a place
that is level and dry.
2. Remove all packaging materials and transport safeguards. Keep the
packaging material, such as plastic bags or Styrofoam away from small
children - danger of suffocation!
3. Check whether all needed parts are present.
4. If necessary, unscrew the screws (10) slightly out of the base.
5. Precisely insert the stand tube (8) into the base and fasten it with the three
screws (firmly tighten the screws clockwise).
6. Fit the operating element (7) onto the stand tube (8). In this process, ensure
that the lower end of the operating element fits precisely onto the holes
intended for this purpose. Fix the two components in place with the screw.
7. You can adjust the desired height by unscrewing the fixing screw, sliding
the tube to the desired height, and fixing it in place with the fixing screw.
8. Fasten the rear basket cover (6) on the motor housing (7), by fixing the cover
in place with the nut (5).
9. Place the impeller (4) on the axle on the motor housing (7). Fix the impeller
(4) in place with the nut (3). Caution: Left-hand thread!
10. Connect the front basket cover (2) to the rear basket cover (6). Check
whether the fastening ring (1) is in the right position (both halves of the
basket must sit precisely in the ring) and fix them in place with the clamp.
11. Check whether all parts have been correctly assembled and fixed in place.

POWERBANK/RECHARGEABLE BATTERY

1
5
3
2
6
4
Copyright UNOLD AG | www.unold.de
1 LEDs – charge status
2 Operating button
3 USD charging input
4 USD charging output
5 Connection, interface –
fan
LED/torch
6
27