Table des Matières
Publicité
Producing light
Principle
• The solar panel must always be in direct sunlight to obtain optimum performance.
• Before fully setting up the device, watch out for possible shadow during the day so
that it can be minimised and unwanted loss of performance can be avoided.
Assembly / display
Hidden / sunken
Check in advance that no power cables are located nearby or can be
damaged. If in doubt contact your public utility supplier.
Screwed-in
The base must be sufficiently solid. Ensure that there is an adequate
distance from the edge of the base to avoid breaking through.
Check in advance that no power cables are located nearby or can be
damaged. If in doubt contact your public utility supplier.
Positioned
Ensure that the light cannot fall and create a danger to traffic
or to people.
Hanging up
Never hang the device on electrical or other public utility cables. Check that
it is affixed tightly to prevent the light from falling in a strong wind.
Floating
The lights may not be positioned in flowing water and is exclusively
intended for private use. Make sure the device is screwed in tightly.
Failure to pay attention can endanger your life!
20
Publicité
Table des Matières
