Water Ace R106 Notice D'utilisation page 2

SAFETY INFORMATION
Use only on a 115 volt circuit.
The pump is equipped with an
Hazardous
voltage
approved 3-conductor cord
and 3-prong, grounding-type plug. To
reduce the risk of electric shock, connect
it to a properly grounded, grounding-type
receptacle.
If circuit has a 2-prong receptacle, replace it
with a properly grounded 3-prong receptacle
installed in accordance with the National
Electrical Code and local codes and ordi-
nances.
Any extension cord used must be outdoor
grade, gauge 16 AWG or heavier, and not
more than 25' long.
Risk of fire or explosion if
used to pump flammable liquids or if used
in explosive atmospheres. Pump water only
with this pump. Pump is designed to pump
water at temperatures between 32°-77° F
(0°-25° C) only.
WA782
Risk of electrical shock. Do
not allow the motor to get wet!
Risk of burns. During normal
operation, motor will normally run hot
enough to burn you. Do not touch motor
when it is hot.
Do not operate the pump continuously at a
discharge pressure of more than 12 psi
(83 kPa) or discharge lift of more than
28' (8.5 M), as the motor will exceed the nor-
mal safe operating temperature and may heat
to 180° - 190° F (82° C - 88° C).
NOTICE: This unit is not designed for applica-
tions involving salt water or brine! Use with
salt water or brine will void warranty.
2