BOMANN BS 971 CB Mode D'emploi page 64

GB
64
05-BS 971 CB 64
Cleaning the Filter Element
Important:
Always empty the dust container fi rst before removing
the fi lter element.
• Press the button to release the dust container and
then remove it (see illustration 1).
• Turn the lid in the direction „ " and then lift it off,
including the fi lter element.
• Turn the fi lter element in the „OPEN" direction to
remove it from the lid. Remove the fi lter element
(two parts) and clean the main fi lter by tapping out
the contents and gently brushing.
• Now replace the components. Please then turn
the fi lter element in the CLOSE direction until it is
tight.
Place the lid on the dust container - the Ú arrow is
•
located above the „ " symbol - and then turn it in
the „ " direction until it is tight.
Every third time the dust container is emptied, or in
the case of severe soiling, clean the fi lter by allowing
water to fl ow through the fi lter fabric against the
direction in which the vacuum cleaner blows. The
dust container should only be reinserted when it is
completely dry!
Now place this back in position once it has completely
dried!
Caution:
Never wash the fi lter in the washing machine, and
please do not use a hairdryer to dry it.
Motor protection fi lter (inlet fi lter)
The inlet fi lter is located in the dust container com-
partment. The fi lter is located vertically in the rear
section of the dust housing. Pull the fi lter out towards
the front. Clean the motor protection fi lter approxi-
mately every 10th time you empty the dust container.
If necessary, the fi lter can also be washed in warm
water without any additives. Place it back into place
only once it is completely dry!
15.08.2005, 10:26:22 Uhr