BOMANN BS 971 CB Mode D'emploi page 61

1 Vacuum hose
2 Hose connection
3 Carrying handle
4 Vacuum power regulator
5 Button for releasing the
new dust container
6 Dust container with fi lter insert
7 On/off switch
8 Accessory holder
9 Floor nozzle
• Insert the connection head of the suction hose into the hose connector until it
locks in place. To do so, please press the buttons simultaneously. In order to
release the hose again, please press the buttons once more on the connection
head.
• Keep the buttons pressed down and then pull out the hose.
• Insert the vacuum tube into the handle if required.
1. Fit on the accessory.
2. Unwind the necessary length of cable and insert the plug in a duly installed
230V/50Hz protective contact socket.
3. Set the vacuum power with the vacuum power regulator.
4. Vacuum at a steady speed. There is no need to exert pressure.
5. Attention: pay attention to the range that can be covered with the cable length.
Vacuum power regulator
Low vacuum power:
Medium vacuum power:
High vacuum power:
Cable winding device
Pull out the cable up to the maximum length indicated with the yellow mark. Never
pull the cable out up to the red mark as the cable winding can be damaged. Said
damages are not covered by the warranty.
Winding
Press the cable winding button and guide the cable. Hold the cable to avoid
wrapping.
05-BS 971 CB 61
Overview of the Components
Start-up
Using the Appliance
For curtains and delicate fabrics
For long-pile velour carpets and textile fl ooring
For sturdy rugs and fl oors
10 Cable-winding key
11 Telescopic suction tube
12 Air slide
13 Cover of outlet fi lter
14 Parking assistance
Accessories:
„2-in-1" nozzle
(groove and brush nozzle)
Upholstery nozzle
GB
61
15.08.2005, 10:26:21 Uhr