Installing The Indoor Housing Assembly With The Thumb Screw - American Dynamics Illustra 625 PTZ Mode D'emploi

English Illustra 625 PTZ Indoor Housing Assembly
5 The indoor housing assembly is now secure.
Note
To remove the indoor housing assembly, rotate slightly and pull to release.
6 Remove the protective film from the bubble.

Installing the Indoor Housing Assembly with the Thumb Screw

Step Action
1 Remove the indoor housing assembly from the packaging and ensure that the bubble is
clean and free from debris.
2 Remove the safety lanyard on the indoor housing assembly.
3 Align the indoor housing assembly with the dome ensuring that the screw hole cutout
aligns with the screw hole on the side of the dome as seen in Figure 4.
4 Maintaining upward pressure slide the indoor housing assembly over the dome to secure.
A positive click will be heard when the indoor housing assembly has fully engaged.
5 The indoor housing assembly is now secure.
6 Insert the supplied M3 thumb screw through screw hole cutout and secure to the indoor
housing assembly as seen in Figure 5.
1-4
- End -
Figure 4
Quick Reference Guide