Installing The Indoor Housing Assembly; Installing The Indoor Housing Assembly With The Safety Lanyard - American Dynamics Illustra 625 PTZ Mode D'emploi

Masquer les pouces Voir aussi pour Illustra 625 PTZ:

Table des Matières

Les langues disponibles

English Illustra 625 PTZ Indoor Housing Assembly

Installing the Indoor Housing Assembly

There are two procedures which can be used to install the Illustra 625 PTZ Indoor Housing

Assembly. Select which procedure is relevant to your installation requirements and follow the

details provided.

• Installing the Indoor Housing Assembly with the Thumb Screw

Note

It is not necessary to disconnect or power down the Illustra 625 PTZ dome before installing or

removing the indoor housing assembly. Unless you are replacing the lock cap.

If using the ADCiM6WALLxK Wall Mount use the safety lanyard procedure for securing the

indoor housing. The thumb screw method is not recommend for use with this wall mount.

If required, replace the original lock cap with the white lock cap supplied with the white version

of the Indoor Housing Assembly.

Installing the Indoor Housing Assembly with the Safety Lanyard

Step

Action

Remove the indoor housing assembly from the packaging and ensure that the bubble is

clean and free from debris.

Attach the safety lanyard on the indoor housing assembly to the screw hole on the dome

using the supplied M3 thumb screw as seen in Figure 1.

1-2

Figure 1

Quick Reference Guide

Table des Matières