Installing The Outdoor Housing - American Dynamics Illustra 625 PTZ Guide De Référence Rapide

Installing the Outdoor Housing

The following describes the installation procedure for the Illustra 625 PTZ Outdoor Camera
Housing.
1 Remove the pendant adapter, threaded adapter, lock nut, external safety lanyard and
lanyard lock from the packaging.
Note
The threaded adapter and lock nut will be required for mounting options that use
the EndCap Mount (ROENDC).
2 Cut a 30cm (12in) length of teflon tape.
3 Apply the teflon tape to the threads on both ends of the threaded adapter.
4 Attach the threaded adapter to the pendant adapter and tighten to secure.
5 Attaching to the EndCap Mount (ROENDC):
If the Illustra 625 PTZ Outdoor Housing is being attached to an existing mount it is essential that
the EndCap (ROENDC) is replaced. Please contact your American Dynamics Sales
Representative for further information.
a Remove the access cover from the EndCap mount as seen in Figure 1.
Pendant Adaptor
Release Pin
Lanyard Lock
Safety Lanyard
English Illustra 625 PTZ Outdoor Housing
Threaded Adaptor
Lock Nut
3