Maintenance - McCulloch Li 58GBP Manuel D'utilisation

Masquer les pouces Voir aussi pour Li 58GBP:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 109
Battery state of charge LED
The status of the battery pack is shown until you pull the
trigger. When you release the trigger, the status of the
battery pack is shown again.
The number of LEDs that are on show the current
charge level of the battery pack.
LED lights
Battery status
All Green LEDs
Fully Charged (100% - 76%)
come on
LED 1, 2 and 3
The battery pack is 75% - 51%
come on
charged.
LED 1 and 2
The battery pack is 50% - 26%
come on
charged.
LED 1 comes on The battery pack is 25% - 6%
charged.
WARNING: Read and understand the safety
chapter before you clean, repair or do
maintenance on the product.
Maintenance schedule
Make sure that you obey the maintenance schedule.
The intervals are calculated from daily use of the
product. The intervals are different if you do not use
the product each day.
Only do the maintenance work that is found in this
manual.
Speak to an approved service center about other
maintenance work not found in this manual.
Daily maintenance
Remove the battery pack. Refer to the operating
instructions of the battery pack for correct

maintenance.

449 - 003 - 20.11.2017
LED lights
LED 1 flashes
Note: If the motor stops and the power LED stays on,
push the button on the battery pack. For possible
solutions, see
Note: When the battery pack is fully discharged, the
motor stops immediately.
Note: The motor automatically stops if the battery pack
or motor controller is too hot during heavy operation. Let
the motor and battery pack cool. The product then
resets.
MAINTENANCE
Examine the nuts, screws and bolts.
Examine the trigger for correct operation.
Examine the power button for correct operation.
Remove external unwanted material from the
product with a soft brush or dry cloth. Do not clean
with water, cleaning fluids, or solvents.
Use a soft brush to remove unwanted material from
the air vents.
Examine the product for missing, damaged, loose or
worn parts.
Examine the product to make sure the moving parts
align and are safe for operation.
If the product is damaged, speak to an approved
service center. Do not use a damaged product.
Battery status
The battery pack is 5% - 0% charg-
ed.
TROUBLESHOOTING on page 12 .
11

Publicité

Table des Matières
loading

Table des Matières