Silverline 40745 Mode D'emploi page 6

GB
Pole installation
WARNING: Do not install the hoist support arm to a pole of the incorrect
diameter. The supporting bar clamps are designed to fit the standard
scaffold tube diameter of 48.3mm. Ensure the pole in use is of the correct
diameter before installation.
1. Hold the Supporting Bar Clamp (11) against the pole at the desired
height for hoist installation
Note: Refer to the hoist's instruction manual for maximum height extension
of the tool.
2. Insert the U-Clamp (7) through the holes in the Supporting Bar Clamp
and around the pole. Secure in place by inserting the U-Clamp into the
Supporting Bar Clamp, and using the Small Flat Washer (19), Small
Spring Washer (17) and M10 Nut (20) to fasten into place.
3. Using the procedure described in steps '1-3', install the Support Arm
Clamp (9) 380mm above the Supporting Bar Clamp, measuring from
U-Clamp to U-Clamp (Fig. I)
4. With assistance from another person, carefully lift the arm assembly so
it is aligned with the Supporting Bar Clamp. Mount the Supporting Bar
(3) to the Supporting Bar Clamp by sliding the Pivot Hole (4) over the
Supporting Bar Mounting Shaft (12) (Image B)
5. Mount the free end of the Support Arm (5) on to the Support Arm
Mounting Shaft (10), and secure both mounting shafts with the Split Pins
(21) provided (Image C)
Hoist installation
WARNING: The maximum load of the hoist support arm with the hoist
mounted on the Extension Bar (6) is 300kg. The maximum load of the hoist
support arm with the hoist mounted on the Supporting Bar (3) is 600kg. This
is inclusive of the hoist's own weight (Fig. II).
Note: Ensure the hoist support arm is securely fastened to the mounting
pole before installing the hoist.
• Use the Plastic Braces (8) when installing the hoist to the Extension Bar
(6) (Image D)
• Sandwich the Plastic Braces between the Extension Bar (6) and the
mounting brackets on the hoist when mounting
• If mounting the hoist to the Supporting Bar (3), it is not necessary to use
the Plastic Braces
Operation
Note: The hoist support arm is capable of freely moving 180° about the axis
of the mounting shafts.
• When lifting loads, use the support arm's ability to move on an axis to
transfer your load securely to the desired location
Accessories
• A range of accessories and consumables, including Electric Hoist 500kg
(442463), Expert Rigger Gloves (633501) and Safety Hard Hat (306429),
is available from your Silverline stockist. Spare parts can be obtained
from toolsparesonline.com
8
Maintenance
General inspection
• Regularly check that all the fixing screws are tight
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts
to wear quickly, and shorten the machine's service life. Clean the body
of your machine with a soft brush, or dry cloth. If available, use clean,
dry, compressed air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do
not use alcohol, petrol or strong cleaning agents
• Never use caustic agents to clean plastic parts
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable
spray lubricant
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the
correct way to dispose of power tools