Lindy 38301 Manuel Utilisateur page 3

User Manual
Introduction
Thank you for purchasing the LINDY Fibre Optic DVI-D Extender!
This Fibre Optic Extender allows you to transmit DVI-D Single Link signals up to maximum
resolutions of 1920x1200 up to a distance of 500m/1600 feet using two standard multimode
50/125µm LC Duplex fibre cables.
Features

Extends DVI-D signals up to 500m/ 1600 feet

Supports DVI-D Single Link, resolutions up to 1920x1200@60Hz, HDCP not supported

Suitable for use with Computer, Video Wall and presentation equipment

May be used with two standard LC Duplex or a 4x LC fibre cables (not included)

Preset EDID data set and Self-EDID learning feature
Package Contents
 LINDY Fibre Optic DVI-D Extender x 2 (1x Transmitter, 1x Receiver)
 Multi-Country Power Adapter (5VDC) x 1
 This User Manual
Do NOT introduce strain or stress to the fibre optic LC cable and connectors!
Do NOT bend the fibre cable below the minimum allowed radius, approximately 5cm -
Pre-Installation Remarks
The EDID preset timings stored in the extender are the following:
1360x768@60Hz; 1920x1080@60Hz; 1920x1200@60Hz; 1600x1200 @60Hz; 1280x1024
@60Hz; 1280x960 @60Hz; 1152x864 @75Hz; 1280x720 @60Hz; 1440x900 @60Hz;
720x400 @70Hz; 640x480 @60Hz; 640x480 @72Hz; 640x480 @75Hz; 800x600 @60Hz;
800x600 @72Hz; 800x600 @75Hz; 1024x768 @60Hz; 1024x768 @70Hz; 1024x768 @75Hz;
1280x1024 @75Hz; 1152x870 @60HZ
Interlaced resolutions and HDCP protected content are not supported.
If the resolution or the timing requirement of your monitor is not included above, the EDID data of
the monitor can be stored into the transmitter by self-learning EDID function, using the steps on
the next page.
Avoid touching it directly and install it with adequate ventilation!
see supplier's specification!
CAUTION!
The Extender may get hot during operation!
English