Table des Matières
Publicité
the display
Note: Before you use the shaver for the first time, remove the protective foil from the display.
The four shaver types (RQ1290, RQ1280, RQ1260 and RQ1250) have different displays, which are shown in the figures below.
-
RQ1290/RQ1280 (Fig. 4)
-
RQ1260 (Fig. 5)
-
RQ1250 (Fig. 6)
charging
-
Charging takes approx. 1 hour.
RQ1290/RQ1280
-
When the shaver is charging, the minutes indication flashes (Fig. 7).
-
The shaving minutes increase until the shaver is fully charged.
-
Quick charge: When the shaver contains enough energy for one shave, the display shows 5 minutes in red.
RQ1260/RQ1250
-
When the shaver is charging, first the bottom charging light flashes, then the second charging light, and so on until the shaver is fully
charged (Fig. 8).
Note: The displays of types RQ1260 and RQ1250 look different, but the charging lights work in the same way.
-
Quick charge: When the shaver contains enough energy for one shave, the bottom charging light alternately flashes orange and white.
Battery fully charged
RQ1290/RQ1280
-
When the battery is fully charged, the minutes indication lights up continuously. After approx. 30 minutes the display automatically switches
off again (Fig. 9).
RQ1260/RQ1250
-
When the battery is fully charged, all charging lights light up continuously. After approx. 30 minutes the display automatically switches off
again. (Fig. 10)
Note: The displays of types RQ1260 and RQ1250 look different, but the charging lights work in the same way.
Battery low
RQ1290/RQ1280
-
When the battery is almost empty (when there are only 5 or fewer shaving minutes left), the minutes indication starts to flash (Fig. 11).
-
When you switch off the shaver, the shaving minutes continue to flash for a few more seconds. You hear a beep when there are no shaving
minutes left.
RQ1260/RQ1250
-
When the battery is almost empty (when there are only 5 or fewer shaving minutes left), the bottom charging light flashes orange. (Fig. 12)
-
When you switch off the shaver, the bottom charging light continues to flash orange for a few seconds.
Note: The displays of types RQ1260 and RQ1250 look different, but the charging lights work in the same way.
Remaining battery capacity
RQ1290/RQ1280
-
The remaining battery capacity is indicated by the number of shaving minutes shown on the display. (Fig. 7)
RQ1260/RQ1250
-
The remaining battery capacity is indicated by the flashing charging lights (Fig. 8).
Note: The displays of types RQ1260 and RQ1250 look different, but the charging lights work in the same way.
clean shaver
For optimal shaving performance, we advise you to clean the shaver after every use.
-
The tap symbol flashes to remind you to clean the shaver (Fig. 13).
Note: The displays of types RQ1290, RQ1280, RQ1260 and RQ1250 look different, but show the same symbol.
Replace shaving unit
For maximum shaving performance, we advise you to replace the shaving unit every year.
-
To remind you to replace the shaving unit, the shaving unit symbol flashes (all types) and you hear a beep when you switch off the shaver
(RQ1290/RQ1280 only). This happens at the end of 7 successive shaves. (Fig. 14)
Note: The displays of types RQ1290, RQ1280, RQ1260 and RQ1250 look different, but show the same symbol.
travel lock (RQ1280/RQ1260/RQ1250 only)
You can lock the shaver when you are going to travel. The travel lock prevents the shaver from being switched on by accident.
activating the travel lock
1
Press the on/off button for 3 seconds to enter the travel lock mode (Fig. 15).
RQ1280: The display starts to count down from 3. At 1, the appliance beeps to indicate that it is locked.
,
The lock symbol lights up on the display. After a few seconds it goes out.
,
Note: The displays of types RQ1280, RQ1260 and RQ1250 look different, but show the same symbol.
Deactivating the travel lock
1
Press the on/off button for 3 seconds.
The motor starts running to indicate that the travel lock has been deactivated.
,
The shaver is now ready for use again.
English
7
Publicité
Table des Matières
