LG G7050 Mode D'emploi page 93

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Settings
Phone lock
When the Phone lock feature is enabled, the phone is locked
and you must enter the phone password each time the phone is
switched on. The password is factory set to 0000. To change the
phone password, refer to the Change codes – Security code
menu option [Menu 9.5.6.1]. Once the correct password has been
entered, you can use the phone until you switch it off.
The following options are available:
1
Power On
]
Enable: You are required to enter the phone password when
you switch the phone on.
]
Disable: You do not need to enter the phone password when
you switch the phone on.
]
If SIM changed: Your phone will request security code only
when you change your SIM card.
2
Once
]
After entering the correct security code, the phone will lock after
going into the idle state. If you want to disable this phone lock,
you should enter the right security code after pressing the right
soft key. If you power off in the phone lock state, when the
phone is next powered on, the phone is in the lock state.
Key lock
This function is only available in the status of the sliding keypad up.
1
Automatic
]
After setting up the automatic mode, then phone is in lock state
after 25 seconds in standby mode with the sliding keypad up.
]
To deactivate key lock, you should press the left soft key
[Unlock] plus star(*) key or slide the keypad down.
84
(Menu 9.5.2)
(Menu 9.5.3)
2
Once
]
Selecting Once puts the phone immediately in the lock state in
standby mode with the sliding keypad up.
]
To deactivate key lock, you should press the left soft key
[Unlock] plus star(*) key or slide the keypad down.
Call barring service
(Network dependent)
Call barring lets you restrict the making and receiving of calls with
your phone. For this function, you need the barring password,
which you can obtain from your service provider.
The following options are available:
]
All outgoing: No call can be made.
]
Outgoing international: International calls cannot be made.
]
Outgoing international except home country:
When abroad, calls can be made only to numbers within the
current country and to your home country, the country where
your home network provider is located.
]
All incoming: No call can be received.
]
Incoming when abroad: Calls cannot be received when you
are using your phone outside your home service area.
]
Cancel all barrings: All call barring settings are deactivated;
calls can be made and received normally.
]
Change password: Use this to set and change the call
barring password obtained from your service provider using this
option. You must enter the current password before you can
specify a new one. Once you have entered a new password,
you are asked to confirm it by entering it again.
Note
To use Call barring service, you must input the network
password. When calls are barred, calls may be possible to
certain emergency numbers on some networks.
Settings
(Menu 9.5.4)
85

Publicité

Chapitres

Table des Matières
loading

Table des Matières