Lowara Ecocirc EB-EBV Série Instructions Pour L'installation Et L'emploi page 17

8. Maintenance/Disassembly
Pumps are subject to wear. If the pump is blocked or grinding noises are audible, check
the pump and replace it if necessary. Procedure:
When replacing non-LOWARA motors, use the additionally included flat seal. The groove
for holding the flat seal in non-LOWARA pump housings has an additional ridge that can
cause leakage when used with an O-ring seal.
9. Troubleshooting
Problem
Pump not running
Pump is noisy
Malfunctioning pumps can be returned to the manufacturer's address. The manufacturer
will refuse to accept packages with unpaid shipping or invoices for repair. The
manufacturer grants a two-year guarantee under the condition of correct installation and
proper use.
- Disconnect pump from the mains.
- Close the connection lines.
- Loosen the union nut and remove the motor (Residual water
may leak out of the rotor cavity. Prevent the electrical
connection to the pump from getting wet.).
Work on electrical parts may only be performed by authorized
specialists.
Cause
- Not connected or
connected incorrectly
- Pump too hot, dry
operation- or overheating
protection active
- Pump blocked
- Not thoroughly bled
- Foreign objects in pump
- Worn bearing
Solution
- Connect correctly
- Allow to cool, pump
restarts automatically
- See section 8
"Maintenance/Disassembly"
- See section 7.2 "Getting
started"
- See section 8
"Maintenance/Disassembly"
- Replace pump
en
17