Ibiza Light LBM-20 Manuel D'utilisation page 3

INSTALLATION
Orientation
This fixture may be mounted in flat position, provided there is adequate room for ventilation
It is important never to obstruct the fan or vents pathway.
When selecting installation location, take into consideration routine maintenance.
Safety cables must always be used.
Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes or
restricted ventilation.
If the external flexible cable or cord of this device is damaged, it shall be exclusively replaced by the manufacturer or
his service agent or a similar qualified person in order to avoid a hazard.
Make sure the installation position is stable before you place the device. We will not take any responsibility for
damages caused by a badly installed unit.
Power Supply Connection
The exclusive plug should be used between the connection of unit and power. Please ensure that the rated voltage
and frequency are accordance with the power supply. The required input voltage and frequency are: 220-240Vac –
50-60Hz
Note: the ground wire (yellow/green double-color wire) must be safely connected; the electrical installation must be
in accordance with the related standards
OPERATION
- Switch the device on in using the power switch located on the rear panel of the bubble machine.
- You will notice that internal bubble drum and fan are activated. Bubbles are now produced.
- Use wireless remote control to activate the production of bubble
Cleaning and Using Frequency of Product
Please make sure that the device is power off before dismantling or maintaining, it's very important to keep the unit
clean. Frequent cleaning will prolong the life time. It's not allowed to use alcohol or chemical solvent.
When the device doesn't work, please check if the fuse is burnt out or not. If it is, the same fuse should be replaced,
find out the faulty and restart the light. But please note the repair must be handled by professional.
TECHNICAL SPECIFICATIONS
Voltage: ........................................................................................................ 220-240Vac∼ 50-60Hz
Power ...................................................................................................................................... 300W
Warming up time ....................................................................................................................... 7mn
Spray distance ............................................................................................................................ 9m
Coverage .............................................................................................................................. 100m2
Fog liquid bottle capacity .......................................................................................................... 2.5L
Dimensions: ..................................................................................................... 500 x 480 x 410mm
N.W .......................................................................................................................................... 10kg
Electric products must not be put into household waste. Please bring them to a recycling centre.
Ask your local authorities or your dealer about the way to proceed.
© Copyright LOTRONIC 2014 LMB20 Page 3