Safety Devices; Use According To Intended Purpose; Residual Risks - Mafell DDF 40 Traduction De La Notice D'emploi Originale

DDF 40 MaxiMAX
Item number 918602, 918620, 918621, 918622,
918623, 918626
2 carbide-tipped dowel drill bits ø 6 mm (0.24 in.)
2 carbide-tipped dowel drill bits ø 8 mm (0.31 in.)
Further scope of delivery DDF 40 MaxiMAX:
1 package wooden dowels ø 6x30 mm (approx. 350
pcs.)
1 package wooden dowels ø 8x30 mm (approx. 200
pcs.)
1 additional support plate ZA
1 additional stop set ZAG
1 hose connector
1 lateral stop set SA 320
1 trim stop LA
1 position indicator PAZ
1 Allen key with handle
1 bottle of glue
1 dowel nozzle ø 8 mm (0.31 in.)
2 anti-slip mats
1 carrying case
1 operating manual
1 folder "Safety instructions"

2.6 Safety devices

Danger
These devices are required for the
machine's safe operation and may
not be removed or rendered
inoperative.
The machine is equipped with the following safety
devices:
- Switch interlock during tool change
- Protection against contact with the drill bits
- Large bearing surfaces of the base plate and tilting
stop
- Handles and handle recesses

2.7 Use according to intended purpose

The duo-dowel system is exclusively designed for
drilling wooden materials using the drill bits approved
by us with a diameter between 3 mm and 12.2 mm
(0.13 and 4.80 in.).
It is used to make connections between individual
parts in the workbench area. The device is not
approved for drilling holes in existing walls.
Grounded machines must be
connected to a properly mounted
socket outlet which is grounded in
accordance with all regulations and
laws. Never remove the ground
contact or modify the plug in any
other way. Have the socket outlet
checked by a qualified electrician if
you have any doubts about the
proper grounding of the socket
outlet.
Danger
Do not interrupt the grounding by
using an adapter plug.
Make sure that the connecting
cable does not touch any rotating
parts.
Any other use than described above is not
permissible. The manufacturer cannot be held liable
for any damage arising from such other use.
In order to use the machine as intended, comply with
the operating, maintenance, and repair instructions
specified by Mafell.

2.8 Residual risks

Danger
Even if used in accordance with its
intended purpose and despite
conforming with the safety
instructions, residual risks caused
by the intended use will always
remain.
- Touching the drill bits inside and outside the base
plate.
- Touching the drill bits on the workpiece rear when
drilling.
- Breakage of the drill bits and risk of the drill bits or
parts of them being hurled away.
- Ejection of chips.
-22-