Read Send Radio Frame Configuration - Michael MBWBLUE Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

A0, A1, A2, A3,
A4, A5, A6, A7:
TL:
NF:
CL:
CM:
[252 bytes]:
To deactivate the radio frame sending, send this command with the correct index IX and [TL] = 0.

Read Send Radio Frame Configuration

This command is used to read the contents of the radio frame buffers configured with "Send Radio
Frames 2".
NOTE: This command is only available with firmware version 3.120 and up.
NOTE: The length byte contains only the LSB of the real length (0x116) of this command.
Request:
Answer OK:
Answer Error:
The parameters are the same as for "Send Radio Frames 2", with the following exception:
IX
CT
Link layer address of the consumption meter to send the radio frame to.
A0 = LSB of manufacturer code
A1 = MSB of manufacturer code
A2 = LSB of serial number
A3 = LSB+1 of serial number
A4 = LSB+2 of serial number
A5 = MSB of serial number
A6 = version number
A7 = device type
It is possible to replace each byte with the M-Bus "wildcard" 0xFF. In this
case, the respective byte is ignored during address comparison.
Number of payload / APL bytes ([252 bytes], usually starting with 2F 2F ...)
Number of "frame to follow" frames to send after initial SND_UD
Configuration word of SND_UD (LSB)
Configuration word of SND_UD (MSB)
Payload / APL of radio frame to send (usually starting with 2F 2F ...)
Using this command the MBWBLUE is automatically building the correct radio
frame by adding LL (link layer) and TPL (transport layer).
It is necessary to always send 252 bytes using this command. The length is
given by TL (see above). Not used bytes should be set to FF.
01 FE 07 4C IX CRC CRC
01 FE 16 4C IX NU CT RM DL S0 S1 S2 A0 A1 A2 A3 A4 A5 A6 A7 TL
[255 bytes] CRC CRC
01 FE 07 4C FF CRC CRC
[0] returns the configuration of the radio frame configured with "Send Radio
Frames", [1...5] returns the configuration of the radio frames configured with
"Send Radio Frames 2".
count on how often the radio frame has already been sent.
If NU = 0 then CT counts up and overflows to 0x00 at 0xFF.
MBWBLUE
23

Publicité

Table des Matières
loading

Produits Connexes pour Michael MBWBLUE

Table des Matières