Receiver Mode; Enable External Serial Interface - Michael MBWBLUE Mode D'emploi

Receiver Mode

Sets the receiver mode (T1/C1 or S1) and receiver frequency (868 MHz or 434 MHz). The 434 MHz
setting is only for testing 434 MHz meters and has only a very short reception range.
NOTE: This command is only available with firmware version 2.200 and up.
Request:
Answer OK:
Answer error:
Mode:

Enable External Serial Interface

Switches the external serial interface on and configures it using the given parameter (all bytes
hexadecimal). By default the external serial interface is switched off and it is turned on by this
command. The serial interface should be switched off if it is no longer used, to save battery energy.
Request:
Answer OK:
Answer error:
BD:
PR:
TO:
01 FE 07 15 Mode CRC CRC
01 FE 07 15 Mode CRC CRC
01 FE 07 15 FF CRC CRC
00: T1/T2/C1, 868 MHz (default after device power-up)
01: S1, 868 MHz
10: T1/T2/C1, 434 MHz
11 : S1, 434 MHz
01 FE 09 12 BD PR TO CRC CRC
01 FE 07 12 00 CRC CRC
01 FE 07 12 FF CRC CRC
Baudrate to use:
00: 300 baud
01: 600 baud
02: 1200 baud
03: 2400 baud
04: 4800 baud
05: 9600 baud
06: 19200 baud
07: 38400 baud
08: 57600 baud
09: 115200 baud
0A: 230400 baud
0B: 460800 baud
AA: switch serial port off
00: 8 bit data no parity
01: 8 bit data + parity odd
02: 8 bit data + parity even
timeout in 0.35 seconds, default = 6 (2.1 seconds)
This is the timeout for waiting for an answer from an external device
connected to the serial interface of the MBWBLUE.
MBWBLUE 17