Michael MBWBLUE Mode D'emploi page 21

CT:
RM:
DL:
S0, S1, S2:
A0, A1, A2, A3,
A4, A5, A6, A7:
delay adjust (DL) in 0.5 ms, set to 0 by default.
01 = DL + 0.5 ms
02 = DL + 1 ms
FF = DL – 0.5 ms
FE = DL – 1 ms
etc.
Radio mode:
Delay between end of reception and sending radio frame [2...254 ms]. Invalid
delays are set to 2 ms.
DL = FF (recommended), automatic delay setting:
Mode T2 = 2 ms
Mode S2 = 10 ms
Mode C2 = 100 ms (D bit in config field of ELL = 1)
Mode C2 = 1000 ms (D bit in config field of ELL = 0)
Transmission speed (chiprate)
100000 chip/s: S2 = 01, S1 = 86, S0 = A0
32768 chip/s: S2 = 00, S1 = 80, S0 = 00
(not supported for FW version 3.xx)
Link layer address of the consumption meter to send the radio frame to.
A0 = LSB of manufacturer code
A1 = MSB of manufacturer code
A2 = LSB of serial number
A3 = LSB+1 of serial number
A4 = LSB+2 of serial number
A5 = MSB of serial number
A6 = version number
A7 = device type
It is possible to replace each byte with the M-Bus "wildcard" 0xFF. In this
case, the respective byte is ignored during address comparison.
MBWBLUE
00 = auto, according to received frame
(T2, S2 or C2)
Ignoring bidirectional bit in config field
10 = auto, according to received frame
(T2, S2 or C2)
Checking bidirectional bit in config field
(C2 only with FW version 3.17 and up)
21